Enter/Exit Programming Mode 2D Symbologies
194
Gryphon™ GPS4400
QR Code Set Length 1
Specifies one of the bar code lengths for QR Code Length Control. Length 1 is
the minimum label length if in Variable Length Mode, or the first fixed length
if in Fixed Length Mode.
Characters can be set from 0001 to 7,089 charac-
ters in increments of 0001 (pad with zeros).
See page 241 for detailed instructions on setting this feature.
Select QR Code Length 1 Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at
left followed by the digits from the Alphanumeric
characters in
Appendix D, Keypad representing your
desired character(s). End by scanning the ENTER/EXIT
bar c
ode again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again
at the beginning.
CANCEL
DEFAULT
0001 = Length 1 is 1 Character
To Next Page
Loading...
Need help?
General