Product Reference Guide 273
Appendix B
Standard Defaults
The most common configuration settings are listed in the “Default” column
of the table below. Page references are also provided for feature descrip-
tions and programming bar codes for each parameter. A column has also
been provided for recording your preferred default
s
ettings for these same
configurable features.
This section shows standard defaults. If your reader was provided with a
custom configuration, your defaults may differ from those shown.
Table 42. Standard Defaults
Parameter Default Your Setting
Page
Number
GL
OBAL INTERFACE FEATURES
Host Commands — Obey/Ignore
Obey
15
RS-232 ONLY
Baud Rate
9600
18
Data Bits
8 Data Bits
19
Stop Bits
1 Stop Bit
19
Parity
None
20
Handshaking Control
RTS
21
RS-232/USB-COM
Intercharacter Delay
No Delay
23
Beep On ASCII BEL
Disable
23
Beep On Not on File
Enable
24
ACK NAK Options
Disable
24
ACK Character
‘ACK’
25
To Next Page
Loading...
Need help?
General