Datalogic Gryphon GPS4421 User Manual

Enter/Exit Programming Mode Reading Parameters
70 Gryphon™ GPS4400
Serial Start Character
$CSTON
Select Serial Start Characters
To configure this feature scan the ENTER/EXIT PRO-
GRAMMING MODE barcode above, then the barcode at
left, follow
ed by the digits (in hex) from the Alphanu-
meric characters in
Appendix D, Keypad repre-
senting your desired character(s). End by scan
ning the
ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode to abort
and not sa
ve the entry string. You can then start again
at the beginning.
~
CANCEL
DEFAULT
0x02 = Serial Start Character is [02 STX]
See page 256 in “References” for more information.
Serial Stop Character
$CSTOF
Select Serial Stop Characters
To configure this feature scan the ENTER/EXIT PRO-
GRAMMING MODE barcode above, then the barcode at
left, follow
ed by the digits (in hex) from the Alphanu-
meric characters in
Appendix D, Keypad repre-
senting your desired character(s). End by scan
ning the
ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode to abort
and not sa
ve the entry string. You can then start again
at the beginning.
~
CANCEL
DEFAULT
0x03 = Serial Stop Character is [03 ETX]
See page 256 in “References” for more information.
The Serial Start/Stop Characters must be different and must not con-
tain reserved chara
cters (see Appendix E, Host Configuration
Reserved Characters
)

Datalogic Gryphon GPS4421 Specifications

General

Brand	Datalogic
Model	Gryphon GPS4421
Category	Scanner
Language	English