Datalogic Gryphon GPS4421 User Manual

Reading Parameters Enter/Exit Programming Mode
Product Reference Guide 73
Aiming Pointer
Enables/disables the aiming pointer for all symbologies.
$CTAAP00(CR)
Aiming Pointer = Disable
$CTAAP01(CR)
Aiming Pointer = Enable
DEFAULT
Aiming Duration Timer
Specifies the time the aiming pointer remains on after decoding a label,
when in On Line or Serial On Line mode.The range for this setting is from 1
to 255 seconds in 1-second increments. See
page 259 in “References”.
DEFAULT
LSTM00
Aiming Off After Decoding
LSTM
Set Aiming Duration Timer
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code , then the bar code at left
followed by t
he digits from the characters in
Appen-
dix D, Keypad representing your desired charac-
ter(s). End by scanning the ENTER/EXIT bar code
again.
M
ake a mistake? Scan the CANCEL bar code to abort
and not sa
ve the entry string. You can then start again
at the beginning.
~
CANCEL

Datalogic Gryphon GPS4421 Specifications

General

Brand	Datalogic
Model	Gryphon GPS4421
Category	Scanner
Language	English