Product Reference Guide
203
Chapter 4
Software Configuration Strings
RS-232 models (as well as USB models with the USB-COM Interface
selected) can be configured using serial strings contained in this chapter.
To configure RS-232 using configu
ration str
ings:
1. Connect your reader to a PC RS-232 port
according to the information
in Attaching Reader to Host, starting on page 6. Set the PC serial port to the
default RS-232 communication parameters (see , starting on page 273).
To configure the reader using configuration strings you must enter Ser-
vice Mode, which automatically sets the reader comm
unication to
115200 baud rate. You must therefore set the host accordingly for RS-
232 communications. Upon exiting Service Mode, the programmed baud
rate will be restored.
2. Using Datalogic Aladdin (available on the Datalogic website) or a Ter-
minal Emulation Program, send the Restore Current Interface (Custom)
Default
string to the reader using the syntax described on "Command
Syntax" on page 204 page.
3. Send all the necessary command strings according to your
application's
requirements.
To configure USB (only for USB-COM Interf
ace) using configuration strings:
USB may have USB-KBD interface set as default. They can be easily
reconfigured by reading the bar codes in
Interface
Selection, starting on page 8
.
1. Download and install the USB-COM driver from www.datalogic.com .
2. Connect your reader to a PC USB port according to the information in
Attaching Reader to Host, starting on page 6.
3. Change the interface to USB-COM by reading the bar code below.
USB-COM
4. Using a Terminal Emulation Program, send the Restore Current Inter-
face (Custom) Default string to the reader using the syntax described
on the next page.
To Next Page
Loading...
Need help?
General