Datalogic Gryphon GPS4421 User Manual

Setup Interface Selection
8 Gryphon™ GPS4400
Interface Selection
The reader has 'Auto Cable Detect' and will power up in the appropriate
interface and type. Your scanner may have been shipped with the desired
interface cable (RS-232 or USB) and the interface type may have been pre-
defined. If you need to change the interf
ace type (example: USB-COM or
USB-KBD), go to
Table 1 below and scan the appropriate bar code in that
section.
The reader will support the following sets of host interfaces:
• RS-232-STD
• RS-232 Wincor-Nixdorf
• USB-COM, USB-OEM, USB-KBD,
USB_KBD-ALT, USB-KBD-Apple
If your installation requires you to select options to customize your reader,
turn to t
h
e appropriate section for your interface type in "Configuration Using
Bar Codes" starting on page 13 (also listed beside each interface type in
Table
1).
Unlike some programming features and options, interface selec-
tions require that you scan only one programming bar code label.
DO NOT scan an ENTER/EXIT bar co
de prior to scanning an interface
selection bar code.
Some interfaces require the scanner to st
art in the disabled state
when powered up. If additional scanner configuration is desired
while in this state, pull the trigger and hold it for five seconds. The
scanner will change to a state that allows programming with bar
codes.
Table 1. Available Interfaces
RS-232 FEATURES
RS-232 standard interface
DEFAULT
Select RS232-STD
Set RS-232
Interface
Features
starting on
page 17
$P,HA12,P(CR)
Select RS232-WN
RS-232 Wincor-Nixdorf
RS-232 for use with OPOS/UPOS/JavaPOS
$P,HA13,P(CR)
Select RS-232 OPOS

Datalogic Gryphon GPS4421 Specifications

General

Brand	Datalogic
Model	Gryphon GPS4421
Category	Scanner
Language	English