2D Symbologies Enter/Exit Programming Mode
Product Reference Guide
189
PDF417 Set Length 2
This feature specifies one of the bar code lengths for PDF417 Length Control.
Length 2 is the maximum label length if in Variable
Length Mode, or the
second fixed length if in Fixed Length Mode. Length includes the bar code’s
check, data, and full-ASCII shift characters. The length does not include
start/stop characters. Characters can be set from 01 to 2,710 characters
(pad with zeros) in increments of 01. Any value greater than 2,710 will be
considered to be 2,710.
See page 241 for detailed instructions on setting this feature.
Select PDF417 Length 2 Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at
left followed by the digits from the Alphanumeric
characters in
Appendix D, Keypad representing your
desired character(s). End by scanning the ENTER/EXIT
bar co
de again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again
at the beginning.
CANCEL
DEFAULT
Length 2 is 2,710 Characters
To Next Page
Loading...
Need help?
General