Enter/Exit Programming Mode Data Format
56
Gryphon™ GPS4400
CODE VERIFIER
This feature allows the scanner to verify that all codes read and decoded
match a defined string saved in its memory. It is valid when in On Line,
Serial On Line, Automatic and Automatic (Object Sense) Operating Modes.
If the code read matches the code verifier Match String
, then it is sent to the
host through the configured port. If it does not match the code verifier
Match String, you can specify whether to send either the Wrong Code or a
defined Wrong String message to indicate the error.
See "Code Verifier" on page 252 in References
for more information about these
features.
Code Verifier Mode
Disable or specify parameters for Code Verifier Mode. See "Code Verifier Mode"
on page 252 in References for more information.
Disabled
Transmit Wrong String
Transmit Wrong Code