Datalogic Gryphon GPS4421 User Manual

Enter/Exit Programming Mode Data Format
44 Gryphon™ GPS4400
Global Prefix/Suffix
This option sets up to 20 characters each from the set of ASCII characters or
any hex value from 00 to FF. The characters may be added as a prefix (in a
position before the bar code data, also called a header) and/or as a suffix
(in a position following the bar code data, also called a footer). See page 244
for more detailed instructions on setting this feature.
To configure this feature,
scan the ENTER/EXIT PROGRAMMING MODE bar
code above to place the unit in Programming Mode, then the “Set Global
Prefix” or “Set Global Suffix,” bar code followed by the digits (in hex) from
the Alphanumeric characters in Appendix D on page 289 representing your
desired character(s). If less than the expected string of 20 characters are
selected
, scan the ENTER/EXIT bar code to terminate the string. Exit pro-
gramming mode by scanning the E
NTER/EXIT bar code again.
$CLFPR
Set Global Prefix
$CLFSU
Set Global Suffix
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
~
CANCEL
DEFAULT
No Global Prefix
Global Suffix = 0x0D (CR)

Datalogic Gryphon GPS4421 Specifications

General

Brand	Datalogic
Model	Gryphon GPS4421
Category	Scanner
Language	English