Reading Parameters Enter/Exit Programming Mode
Product Reference Guide
69
Phase Off Event
Trigger Stop
DEFAULT
Timeout
Trigger Stop - Timeout
Phase Off Timeout
Timeout can be set within a range of 1second to 255 seconds in 1 second
intervals.
Scanning Active Time
To configure this feature scan the ENTER/EXIT PRO-
GRAMMING MODE barcode above, then the barcode at
left, follow
ed by the digits (in hex) from the Alphanu-
meric characters in
Appendix D, Keypad
repre-
senting your desired character(s). End by scan
ning the
ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode to abort
and not sa
ve the entry string. You can then start again
at the beginning.
CANCEL
DEFAULT
5 = Timeout set for 5 seconds
To Next Page
Loading...
Need help?
General