Datamax E-Class Mark II - Page 113

Extended System-Level Command Functions
Class Series 2 Programmer’s Manual 101
(WS) WiFi Security – This command configures WiFi security.
Value Parameter WiFi Interpretation Default Value
xy
Is the WEP Key, where x:
1 = WEP Key 1
2 = WEP Key 2
3 = WEP Key 3
4 = WEP Key 4
And where y:
Is the Key, up to 26 characters with no spaces.
1
(See Note 1)
A x
Is the Security Authentication, where x:
0 = Auto
1 = Open
2 = Shared
0
K x
Is the WEP Default Key, where x:
1 = WEP Key 1
2 = WEP Key 2
3 = WEP Key 3
4 = WEP Key 4
1
S x
Is the Security setting, where x:
0 = Disabled
1 = WEP 64 Bit
2 = WEP 128 Bit
3 = WPA PSK
4 = WPA LEAP
5 = WPA LEAP 64
6 = WPA LEAP 128
7 = WPA PSK+TKIP 64
8 = WPA PSK+TKIP 128
0
L y
Is the LEAP Password, where y:
Is up to 32 characters.
See Note 2
P y
Is the WPA Passphrase (Preshared Key), where
y:
Is 8 to 63 characters with no spaces; or, 64 hex
characters.
See Note 3
U y
Is the LEAP User ID, where y:
Is up to 32 characters.
See Note 4
1. Default values for WEP Keys are all zeros (whether 10 digit or 26 digits).
2. The LEAP password is 1 to 32 characters and must match the LEAP password assigned
to the LEAP user on the LEAP server. The password cannot contain spaces.
3. The WPA passphrase must match the passphrase on the Access Point.
4. The User ID cannot contain spaces.
Table 5-14 WiFi Security