160 Fax
If you are at the machine, lift the external telephone’s handset, and then press the button in the following table to
answer.
Applicable Models To pick up voice call
Dell E515dn/Dell E515dw
Hook
If you are at an extension telephone, lift the handset during the F/T Ring and then press #51 between the pseudo/
double rings. If no one is on the line, or if someone wants to send you a fax, send the call back to the machine by
pressing *51.
Special Line Considerations
• Rollover Telephone Lines
A rollover telephone system is a group of two or more separate telephone lines that pass incoming calls to each
other if they are busy.
• Two-Line Telephone System
A two-line telephone system is nothing more than two separate telephone numbers on the same wall outlet.
• Convert Telephone Wall Outlets
• Install Your Dell Machine, a External Two-Line TAD and Two-Line Telephone
When you are installing an external two-line telephone answering device (TAD) and a two-line telephone, your
machine must be isolated on one line at both the wall jack and at the TAD.
Rollover Telephone Lines
Related Models:Dell E515dn / Dell E515dw
A rollover telephone system is a group of two or more separate telephone lines that pass incoming calls to each other
if they are busy.
This feature is available only in the USA and Canada.
The calls are usually passed down or 'rolled over' to the next available telephone line in a preset order.
Your machine can work in a rollover system only if it is the last number in the sequence, so the call cannot roll
away. Do not place the machine on any of the other numbers; when the other lines are busy and a second fax call is
received, the fax call would be transferred to a line that does not have a fax machine. Your machine will work best
on a dedicated line.
Two-Line Telephone System
Related Models:Dell E515dn / Dell E515dw
A two-line telephone system is nothing more than two separate telephone numbers on the same wall outlet.
This feature is available only in the USA and Canada.
The two telephone numbers can be on separate jacks (RJ11) or combined into one jack (RJ14). Your machine must be
plugged into an RJ11 jack. RJ11 and RJ14 jacks may be equal in size and appearance and both may contain four wires
(black, red, green, yellow). To test the type of jack, plug in a two-line telephone and see if it can access both lines. If
it can, you must separate the line for your machine.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
