Figure 36. Configuration 7: 10 x 2.5 inch (NVMe) (1CPU)
NOTE:
Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 78. 10 x 2.5 inch (NVMe) (1CPU)
Order From To
1 SIG_PWR_1 (system board power
connector)
BP_PWR_1 (backplane power connector)
2 SL3_CPU1_PA2 (signal connector on
system board)
BP_DST_PA1 (backplane signal connector)
3 SL4_CPU1_PB2 (signal connector on
system board)
BP_DST_PB1 (backplane signal connector)
4 SL7_CPU1_PB4 (signal connector on
system board)
BP_DST_PA2 (backplane signal connector)
5 SL8_CPU1_PA4 (signal connector on
system board)
BP_DST_PB2 (backplane signal connector)
Installing and removing system components 81
To Next Page
Loading...
