Dell PowerEdge R660 - Page 82

Figure 37. Configuration 8: 10 x 2.5 inch (SAS/SATA) + 2 x 2.5 inch (SAS/SATA) (fPERC12)
NOTE:
Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 79. 10 x 2.5 inch (SAS/SATA) + 2 x 2.5 inch (SAS/SATA) (fPERC12)
Order From To
1 SIG_PWR_1 (system board power
connector)
BP_PWR_1 (backplane power connector)
2 SL3_CPU1_PA2 (signal connector on
system board)
CTRL_DST_PA1 (fPERC input connector)
3 CTRL_SRC_SB1 (front PERC
controller connector)
BP_DST_SB1 (backplane signal connector) and R_BP_DST_SA1
(rear backplane signal connector)
4 CTRL_SRC_SA1_PA1 (front PERC
controller connector)
BP_DST_SA1 (backplane signal connector)
5 SIG_PWR_0 (system board power
connector)
R_BP_PWR_1 (rear backplane power connector)
6 SL4_CPU1_PB2 (signal connector on
system board)
CTRL_DST_PB1 (fPERC input connector)
NOTE: Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
82 Installing and removing system components