Dell PowerEdge R660 - Page 83

Figure 38. Configuration 9: 10 x 2.5 inch (SAS/SATA w/ 4 Universal) (fPERC12)
NOTE:
Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 80. 10 x 2.5 inch (SAS/SATA w/ 4 Universal) (fPERC12)
Order From To
1 SIG_PWR_1 (system board power
connector)
BP_PWR_1 (backplane power connector)
2 SL3_CPU1_PA2 (signal connector on
system board)
CTRL_DST_PA1 (fPERC input connector)
3 CTRL_SRC_SB1 (fPERC controller
connector)
BP_DST_SB1 (backplane expander signal connector)
4 SL4_CPU1_PB2 (signal connector on
system board)
CTRL_DST_PB1 (fPERC input connector)
5 SL8_CPU1_PA4 (signal connector on
system board)
BP_DST_PA3 (backplane signal connector)
6 CTRL_SRC_SA1_PA1 (fPERC
controller connector)
BP_DST_SA1 (backplane signal connector)
7 SL2_CPU2_PB1 (signal connector on
system board)
BP_DST_PB2 (backplane signal connector)
Installing and removing system components 83