Dell PowerEdge R660 - Page 85

Figure 40. Configuration 11: 10 x 2.5 inch (SAS/SATA) (fPERC11) (Min Config)
NOTE:
Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 82. 10 x 2.5 inch (SAS/SATA) (fPERC11) (Min Config) 
Order From To
1 SIG_PWR_1 (system board power
connector)
BP_PWR_1 (backplane power connector)
2 SL3_CPU1_PA2 (signal connector on
system board)
CTRL_DST_PA1 (fPERC input connector)
3 CTRL_SRC_SB1 (fPERC controller
connector)
BP_DST_SB1 (backplane signal connector)
Installing and removing system components 85