Dell PowerEdge R660 - Page 86

Figure 41. Configuration 12: 10 x 2.5 inch (SAS/SATA w/ 4 Universal) (fPERC11)
NOTE:
Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 83. 10 x 2.5 inch (SAS/SATA w/ 4 Universal) (fPERC11)
Order From To
1 SIG_PWR_1 (system board power
connector)
BP_PWR_1 (backplane power connector)
2 SL3_CPU1_PA2 (signal connector on
system board)
CTRL_DST_PA1 (fPERC input connector)
3 CTRL_SRC_SB1 (front PERC
controller connector)
BP_DST_SB1 (backplane signal connector)
4 SL2_CPU2_PB1 (signal connector on
system board)
BP_DST_PB2 (backplane signal connector)
5 SL4_CPU1_PB2 (signal connector on
system board)
BP_DST_PA3 (backplane signal connector)
86 Installing and removing system components