Dell PowerEdge R660 - Page 92

Figure 47. Configuration 18: BOSS-N1 cable
NOTE:
Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 89. BOSS-N1 cable 
Order From To
1 BOSS_PWR (BOSS-N1 power connector
on system board)
BOSS_PWR (BOSS-N1 power connector on BOSS-N1 module)
2 SL12_PCH_PA6 (BOSS-N1 signal cable on
the system board)
CTRL_DST_PA1 (BOSS N1 signal cable on the BOSS-N1
module)
Figure 48. Configuration 19: 8 x 2.5 inch Universal Smart Flow (2 CPU) (fPERC11)
92
Installing and removing system components