Dell PowerEdge R660 - Page 94

Figure 49. Configuration 20: 8 x 2.5 inch Universal Smart Flow (H965) (2 CPU) (fPERC12)
NOTE:
Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 91. 8 x 2.5 inch Universal Smart Flow (H965) (2 CPU) (fPERC12)
Order From To
1 SIG_PWR_1 (system board power
connector)
BP_PWR_1 (backplane power connector)
2 SL3_CPU1_PA2 (signal connector on
system board)
CTRL_DST_PA1 (fPERC input connector)
3 CTRL_SRC_SA1 (fPERC controller
connector)
BP_DST_SA1 (backplane signal connector) and BP_DST_SB1
(backplane signal connector)
4 BP_PWR_CTRL (backplane power
connector)
FPERC_GF
5 SL4_CPU1_PB2 (signal connector on
system board)
CTRL_DST_PB1 (fPERC input connector)
6 SL1_CPU2_PA1 (signal connector on
system board)
BP_DST_PA1 (backplane signal connector)
7 SL7_CPU1_PB4 (signal connector on
system board)
BP_DST_PB1 (backplane signal connector)
8 SL8_CPU1_PA4 (signal connector on
system board)
BP_DST_PA2 (backplane signal connector)
9 SL11_CPU1_PB7 (signal connector on
system board)
BP_DST_PB2 (backplane signal connector)
94 Installing and removing system components