Dell PowerEdge R660 - Page 97

Figure 52. Configuration 23:14 x EDSFF E3.S (Gen5x4 NVMe), min config
NOTE:
Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 94. 14 x EDSFF E3.S (Gen5 x4 NVMe), min config
Order From To
1 SIG_PWR_1 (system board power
connector)
BP_PWR_1 (backplane power connector)
2 SIG_PWR_2 (system board power
connector)
BP_PWR_1 (backplane power connector)
3 SL1_CPU2_PA1 (signal connector on
system board)
BP_DST_PA1 (backplane signal connector)
4 SL2_CPU2_PB1 (signal connector on
system board)
BP_DST_PB1 (backplane signal connector)
5 SL5_CPU2_PB3 (signal connector on
system board)
BP_DST_PA2 (backplane signal connector)
6 SL6_CPU2_PA3 (signal connector on
system board)
BP_DST_PB2 (backplane signal connector)
7 SL3_CPU1_PA2 (signal connector on
system board)
BP_DST_PA1 (backplane signal connector)
8 SL4_CPU1_PB2 (signal connector on
system board)
BP_DST_PB1 (backplane signal connector)
9 SL8_CPU1_PA4 (signal connector on
system board)
BP_DST_PB2 (backplane signal connector)
Installing and removing system components 97