Dell PowerEdge R660 - Page 98

Figure 53. Configuration 24: 14 x EDSFF E3.S + 2 x EDSFF E3.S (Gen5 x 4 NVMe)
NOTE:
Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 95. 14 x EDSFF E3.S + 2 x EDSFF E3.S (Gen5 x 4 NVMe)
Order From To
1 SIG_PWR_1 (system board power
connector)
BP_PWR_1 (backplane power connector)
2 SIG_PWR_2 (system board power
connector)
BP_PWR_1 (backplane power connector)
3 SL1_CPU2_PA1 (signal connector on
system board)
BP_DST_PA1 (backplane signal connector)
4 SL2_CPU2_PB1 (signal connector on
system board)
BP_DST_PB1 (backplane signal connector)
5 SL5_CPU2_PB3 (signal connector on
system board)
BP_DST_PA2 (backplane signal connector)
6 SL6_CPU2_PA3 (signal connector on
system board)
BP_DST_PB2 (backplane signal connector)
7 SL3_CPU1_PA2 (signal connector on
system board)
BP_DST_PA1 (backplane signal connector)
8 SL4_CPU1_PB2 (signal connector on
system board)
BP_DST_PB1 (backplane signal connector)
9 SL8_CPU1_PA4 (signal connector on
system board)
BP_DST_PB2 (backplane signal connector)
10 SIG_PWR_0(system board power
connector)
BP_PWR_1 (backplane power connector)
11 SL11_CPU1_PB7 (signal connector on
system board)
R_BP_DST_PA1 (rear backplane signal connector)
98 Installing and removing system components