Example of Viewing OSPF Conguration
Dell#show run ospf
!
router ospf 4
router-id 4.4.4.4
network 4.4.4.0/28 area 1
!
ipv6 router ospf 999
default-information originate always
router-id 10.10.10.10
Dell#
Sample Congurations for OSPFv2
The following congurations are examples for enabling OSPFv2.
These examples are not comprehensive directions. They are intended to give you some guidance with typical congurations.
You can copy and paste from these examples to your CLI. To support your own IP addresses, interfaces, names, and so on, be sure that you
make the necessary changes.
Basic OSPFv2 Router Topology
The following illustration is a sample basic OSPFv2 topology.
Figure 89. Basic Topology and CLI Commands for OSPFv2
OSPF Area 0 — Te 1/1 and 1/2
router ospf 11111
network 10.0.11.0/24 area 0
network 10.0.12.0/24 area 0
network 192.168.100.0/24 area 0
!
interface GigabitEthernet 1/1
ip address 10.1.11.1/24
no shutdown
!
interface GigabitEthernet 1/2
ip address 10.2.12.2/24
no shutdown
!
Open Shortest Path First (OSPFv2 and OSPFv3)
561
To Next Page
Loading...
Need help?
General
