Dell S3048-ON User Manual

3 vty 1 10.14.1.97
4 vty 2 10.14.1.97
5 vty 3 10.14.1.97
Kill existing session? [line number/Enter to cancel]:
Enabling Secured CLI Mode
The secured CLI mode prevents the users from enhancing the permissions or promoting the privilege levels.
• Enter the following command to enable the secured CLI mode:
CONFIGURATION Mode
secure-cli enable
After entering the command, save the running-conguration. Once you save the running-conguration, the secured CLI mode is enabled.
If you do not want to enter the secured mode, do not save the running-conguration. Once saved, to disable the secured CLI mode, you
need to manually edit the startup-conguration le and reboot the system.
Log Messages in the Internal Buer
All error messages, except those beginning with %BOOTUP (Message), are log in the internal buer.
For example, %BOOTUP:RPM0:CP %PORTPIPE-INIT-SUCCESS: Portpipe 0 enabled
Conguration Task List for System Log Management
There are two conguration tasks for system log management:
• Disable System Logging
• Send System Messages to a Syslog Server
Disabling System Logging
By default, logging is enabled and log messages are sent to the logging buer, all terminal lines, the console, and the syslog servers.
To disable system logging, use the following commands.
• Disable all logging except on the console.
CONFIGURATION mode
no logging on
• Disable logging to the logging buer.
CONFIGURATION mode
no logging buffer
• Disable logging to terminal lines.
CONFIGURATION mode
no logging monitor
• Disable console logging.
CONFIGURATION mode
no logging console
72
Management

Dell S3048-ON Specifications

General

Rack Units	1U
Form Factor	Rack-mountable
Input Voltage	100-240V AC
Power Supply	2 hot-swappable power supplies
Management	CLI, Web, SNMP
Product Type	Switch
MAC Address Table Size	32K entries
Jumbo Frame Support	Yes
Latency	< 3 microseconds
Ports	48 x 1GbE RJ45, 4 x 10GbE SFP+