EasyManuals Logo

Dell S3048-ON User Manual

Dell S3048-ON
1036 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #930 background imageLoading...
Page #930 background image
PVLAN Operations When One VLT Peer is Down
When a VLT port moves to the Admin or Operationally Down state on only one of the VLT nodes, the VLT Lag is still considered to be up. All
the PVLAN MAC entries that correspond to the operationally down VLT LAG are maintained as synchronized entries in the device. These
MAC entries are removed when the peer VLT LAG also becomes inactive or a change in PVLAN conguration occurs.
PVLAN Operations When a VLT Peer is Restarted
When the VLT peer node is rebooted, the VLAN membership of the VLTi link is preserved and when the peer node comes back online, a
verication is performed with the newly received PVLAN conguration from the peer. If any dierences are identied, the VLTi link is either
added or removed from the VLAN. When the peer node restarts and returns online, all the PVLAN congurations are exchanged across the
peers. Based on the information received from the peer, a bulk synchronization of MAC addresses that belong to spanned PVLANs is
performed.
During the booting phase or when the ICL link attempts to come up, a system logging message is recorded if VLT PVLAN mismatches,
PVLAN mode mismatches, PVLAN association mismatches, or PVLAN port mode mismatches occur. Also, you can view these
discrepancies if any occur by using the show vlt mismatch command.
Interoperation of VLT Nodes in a PVLAN with ARP Requests
When an ARP request is received, and the following conditions are applicable, the IP stack performs certain operations.
The VLAN on which the ARP request is received is a secondary VLAN (community or isolated VLAN).
Layer 3 communication between secondary VLANs in a private VLAN is enabled by using the ip local-proxy-arp command in
INTERFACE VLAN conguration mode.
The ARP request is not received on the ICL
Under such conditions, the IP stack performs the following operations:
The ARP reply is sent with the MAC address of the primary VLAN.
The ARP request packet originates on the primary VLAN for the intended destination IP address.
The ARP request received on ICLs are not proxied, even if they are received with a secondary VLAN tag. This behavior change occurs
because the node from which the ARP request was forwarded would have replied with its MAC address, and the current node discards the
ARP request.
Scenarios for VLAN Membership and MAC Synchronization
With VLT Nodes in PVLAN
The following table illustrates the association of the VLTi link and PVLANs, and the MAC synchronization of VLT nodes in a PVLAN (for
various modes of operations of the VLT peers):
930
Virtual Link Trunking (VLT)

Table of Contents

Other manuals for Dell S3048-ON

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dell S3048-ON and is the answer not in the manual?

Dell S3048-ON Specifications

General IconGeneral
Rack Units1U
Form FactorRack-mountable
Input Voltage100-240V AC
Power Supply2 hot-swappable power supplies
ManagementCLI, Web, SNMP
Product TypeSwitch
MAC Address Table Size32K entries
Jumbo Frame SupportYes
Latency< 3 microseconds
Ports48 x 1GbE RJ45, 4 x 10GbE SFP+

Related product manuals