Dell S3048-ON User Manual

• Congure GVRP Registration
• Congure a GARP Timer
• RPM Redundancy
Congure GVRP
To begin, enable GVRP.
To facilitate GVRP communications, enable GVRP globally on each switch. Then, GVRP conguration is per interface on a switch-by-switch
basis. Enable GVRP on each port that connects to a switch where you want GVRP information exchanged. In the following example, GVRP
is congured on VLAN trunk ports.
Figure 33. Global GVRP Conguration Example
Basic GVRP conguration is a two-step process:
1 Enabling GVRP Globally
2 Enabling GVRP on a Layer 2 Interface
Related Conguration Tasks
• Congure GVRP Registration
• Congure a GARP Timer
284
GARP VLAN Registration Protocol (GVRP)

Dell S3048-ON Specifications

General

Rack Units	1U
Form Factor	Rack-mountable
Input Voltage	100-240V AC
Power Supply	2 hot-swappable power supplies
Management	CLI, Web, SNMP
Product Type	Switch
MAC Address Table Size	32K entries
Jumbo Frame Support	Yes
Latency	< 3 microseconds
Ports	48 x 1GbE RJ45, 4 x 10GbE SFP+