2 2 up up 7200
2 3 up up 7200
3 1 up up 7200
3 2 up up 7200
3 3 up up 7200
4 1 up up 7200
4 2 up up 7200
4 3 up up 7200
The following example shows how to congure two new switches for stacking using 10G ports.
Dell-1(conf)#stack-unit 1 stack-group 1
Setting ports Te 1/50 as stack group will make their interface configs obsolete after
a reload.
[confirm yes/no]:yes
Dell-2(conf)#stack-unit 2 stack-group 0
Setting ports Te 2/49 as stack group will make their interface configs obsolete after
a reload.
[confirm yes/no]:yes
Dell-1#show system stack-ports
Topology: Ring
Interface Connection Link Speed Admin Link
(Gb/s) Status Status
---------------------------------------------------------
1/50 2/49 10 up up
Add Units to an Existing Stack
You can add units to an existing stack in one of three ways.
• By manually assigning a new uncongured unit a position in an existing stack.
• By adding a congured unit to an existing stack.
• By merging two stacks.
If you are adding units to an existing stack, you can either:
• allow Dell Networking OS to automatically assign the new unit a position in the stack, or
• manually determine each units position in the stack by conguring each unit to correspond with the stack before connecting it.
• If you add a unit that has a stack number that conicts with the stack, the stack assigns the rst available stack number.
• If the stack has a provision for the stack-number that will be assigned to the new unit, the provision must match the unit type, or Dell
Networking OS generates a type mismatch error.
After the new unit loads, it synchronizes its running and startup congurations with the stack.
Manually Assigning a New Unit to an Existing Stack
To manually assign a new unit a position in an existing stack, use the following steps.
1 On the stack, determine the next available stack-unit number, and the management priority of the management unit.
EXEC Privilege mode
show system brief or show system stack-unit
2 On the new unit, number it the next available stack-unit number.
EXEC Privilege mode
stack-unit stack-unit-number renumber stack-unit-new-number
810
Stacking
To Next Page
Loading...
Need help?
General
