Dell S3048-ON User Manual

Sending System Messages to a Syslog Server
To send system messages to a specied syslog server, use the following command. The following syslog standards are supported: RFC
5424 The SYSLOG Protocol, R.Gerhards and Adiscon GmbH, March 2009, obsoletes RFC 3164 and RFC 5426 Transmission of Syslog
Messages over UDP.
• Specify the server to which you want to send system messages. You can congure up to eight syslog servers.
CONFIGURATION mode
logging {ip-address | ipv6-address | hostname} {{udp {port}} | {tcp {port}}}
You can export system logs to an external server that is connected through a dierent VRF.
Conguring a UNIX System as a Syslog Server
To congure a UNIX System as a syslog server, use the following command.
• Congure a UNIX system as a syslog server by adding the following lines to /etc/syslog.conf on the UNIX system and assigning write
permissions to the le.
• Add line on a 4.1 BSD UNIX system. local7.debugging /var/log/ftos.log
• Add line on a 5.7 SunOS UNIX system. local7.debugging /var/adm/ftos.log
In the previous lines, local7 is the logging facility level and debugging is the severity level.
Changing System Logging Settings
You can change the default settings of the system logging by changing the severity level and the storage location.
The default is to log all messages up to debug level, that is, all system messages. By changing the severity level in the logging commands,
you control the number of system messages logged.
To specify the system logging settings, use the following commands.
• Specify the minimum severity level for logging to the logging buer.
CONFIGURATION mode
logging buffered level
• Specify the minimum severity level for logging to the console.
CONFIGURATION mode
logging console level
• Specify the minimum severity level for logging to terminal lines.
CONFIGURATION mode
logging monitor level
• Specify the minimum severity level for logging to a syslog server.
CONFIGURATION mode
logging trap level
• Specify the minimum severity level for logging to the syslog history table.
CONFIGURATION mode
logging history level
Management
73

Dell S3048-ON Specifications

General

Rack Units	1U
Form Factor	Rack-mountable
Input Voltage	100-240V AC
Power Supply	2 hot-swappable power supplies
Management	CLI, Web, SNMP
Product Type	Switch
MAC Address Table Size	32K entries
Jumbo Frame Support	Yes
Latency	< 3 microseconds
Ports	48 x 1GbE RJ45, 4 x 10GbE SFP+