To validate the software image on the îš‚ash drive after the image is transferred to the system, but before you install the image, use the
verify {md5 | sha256} [ flash://]img-file [hash-value] command in EXEC mode.
• md5: MD5 message-digest algorithm
• sha256: SHA256 Secure Hash Algorithm
• flash: (Optional) Species the ash drive. The default uses the ash drive. You can enter the image le name.
• hash-value: (Optional). Specify the relevant hash published on iSupport.
• img-file: Enter the name of the Dell Networking software image le to validate
Examples: Without Entering the Hash Value for Verication
MD5
Dell# verify md5 flash://FTOS-SE-9.5.0.0.bin
MD5 hash for FTOS-SE-9.5.0.0.bin: 275ceb73a4f3118e1d6bcf7d75753459
SHA256
Dell# verify sha256 flash://FTOS-SE-9.5.0.0.bin
SHA256 hash for FTOS-SE-9.5.0.0.bin:
e6328c06faf814e6899ceead219afbf9360e986d692988023b749e6b2093e933
Examples: Entering the Hash Value for Verication
MD5
Dell# verify md5 flash://FTOS-SE-9.5.0.0.bin 275ceb73a4f3118e1d6bcf7d75753459
MD5 hash VERIFIED for FTOS-SE-9.5.0.0.bin
SHA256
Dell# verify sha256 flash://FTOS-SE-9.5.0.0.bin
e6328c06faf814e6899ceead219afbf9360e986d692988023b749e6b2093e933
SHA256 hash VERIFIED for FTOS-SE-9.5.0.0.bin
Using HTTP for File Transfers
Stating with Release 9.3(0.1), you can use HTTP to copy les or conguration details to a remote server. To transfer les to an external
server, use the copy source-le-url http://host[:port]/le-path command.
Enter the following source-le-url keywords and information:
• To copy a le from the internal FLASH, enter ash:// followed by the lename.
• To copy the running conguration, enter the keyword running-cong.
• To copy the startup conguration, enter the keyword startup-cong.
• To copy a le on the USB device, enter usbash:// followed by the lename.
In the Dell Networking OS release 9.8(0.0), HTTP services support the VRF-aware functionality. If you want the HTTP server to use a VRF
table that is attached to an interface, congure that HTTP server to use a specic routing table. You can use the ip http vrf command
to inform the HTTP server to use a specic routing table. After you congure this setting, the VRF table is used to look up the destination
address.
NOTE
: To enable HTTP to be VRF-aware, as a prerequisite you must rst dene the
VRF.
You can specify either the management VRF or a nondefault VRF to
congure the VRF awareness setting.
When you specify the management VRF, the copy operation that is used to transfer les to and from an HTTP server utilizes the VRF table
corresponding to the Management VRF to look up the destination. When you specify a nondefault VRF, the VRF table corresponding to
that nondefault VRF is used to look up the HTTP server.
58
Getting Started
To Next Page
Loading...
Need help?
General
