Dell S3048-ON

Example of Viewing sFlow Conguration (Global)
The rst bold line indicates sFlow is globally enabled.
The second bold lines indicate sFlow is enabled on Gi 1/16 and Gi 1/17
Dell#show sflow
sFlow services are enabled
Global default sampling rate: 32768
Global default counter polling interval: 20
1 collectors configured
Collector IP addr: 133.33.33.53, Agent IP addr: 133.33.33.116, UDP port: 6343
77 UDP packets exported
0 UDP packets dropped
165 sFlow samples collected
69 sFlow samples dropped due to sub-sampling
Stack-unit 1 Port set 0 H/W sampling rate 8192
Gi 1/16: configured rate 8192, actual rate 8192, sub-sampling rate 1
Gi 1/17: configured rate 16384, actual rate 16384, sub-sampling rate 2
Displaying Show sFlow on an Interface
To view sFlow information on a specic interface, use the following command.
• Display sFlow conguration information and statistics on a specic interface.
EXEC mode
show sflow interface interface-name
Examples of the sFlow show Commands
The following example shows the show sflow interface command.
Dell#show sflow interface gigabitethernet 1/1
Gi 1/1
sFlow type :Ingress
Configured sampling rate :16384
Actual sampling rate :16384
Counter polling interval :20
Extended max header size :128
Samples rcvd from h/w :0
The following example shows the show running-config interface command.
Dell#show running-config interface gigabitethernet 1/16
!
interface GigabitEthernet 1/16
no ip address
switchport
sflow ingress-enable
sflow sample-rate 8192
no shutdown
Displaying Show sFlow on a Stack-unit
To view sFlow statistics on a specied Stack-unit, use the following command.
• Display sFlow conguration information and statistics on the specied interface.
EXEC mode
show sflow stack—unit slot-number
760
sFlow