Dell S3048-ON User Manual

Disabling and Undoing LLDP
To disable or undo LLDP, use the following command.
• Disable LLDP globally or for an interface.
disable
To undo an LLDP conguration, precede the relevant command with the keyword no.
Enabling LLDP on Management Ports
LLDP on management ports is enabled by default.
To enable LLDP on management ports, use the following command.
1 Enter Protocol LLDP mode.
CONFIGURATION mode
protocol lldp
2 Enter LLDP management-interface mode.
LLDP-MANAGEMENT-INTERFACE mode
management-interface
3 Enable LLDP.
PROTOCOL LLDP mode
no disable
Disabling and Undoing LLDP on Management Ports
To disable or undo LLDP on management ports, use the following command.
1 Enter Protocol LLDP mode.
CONFIGURATION mode.
protocol lldp
2 Enter LLDP management-interface mode.
LLDP-MANAGEMENT-INTERFACE mode.
management-interface
3 Enter the disable command.
LLDP-MANAGEMENT-INTERFACE mode.
To undo an LLDP management port conguration, precede the relevant command with the keyword no.
Advertising TLVs
You can congure the system to advertise TLVs out of all interfaces or out of specic interfaces.
• If you congure the system globally, all interfaces send LLDPDUs with the specied TLVs.
• If you congure an interface, only the interface sends LLDPDUs with the specied TLVs.
• If you congure LLDP both globally and at interface level, the interface level conguration overrides the global conguration.
458
Link Layer Discovery Protocol (LLDP)

Dell S3048-ON Specifications

General

Rack Units	1U
Form Factor	Rack-mountable
Input Voltage	100-240V AC
Power Supply	2 hot-swappable power supplies
Management	CLI, Web, SNMP
Product Type	Switch
MAC Address Table Size	32K entries
Jumbo Frame Support	Yes
Latency	< 3 microseconds
Ports	48 x 1GbE RJ45, 4 x 10GbE SFP+