ROUTER ISIS mode
redistribute ospf process-id [level-1| level-1-2 | level-2] [metric value] [match external {1
| 2} | match internal] [metric-type {external | internal}] [route-map map-name]
Congure the following parameters:
• process-id the range is from 1 to 65535.
• level-1, level-1-2, or level-2: assign all redistributed routes to a level. The default is level-2.
• metric value the range is from 0 to 16777215. The default is 0.
• match external the range is from 1 or 2.
• match internal
• metric-type: external or internal.
• map-name: enter the name of a congured route map.
Redistributing IPv6 Routes
To add routes from other routing instances or protocols, use the following commands.
NOTE: These commands apply to IPv6 IS-IS only. To apply prex lists to IPv4 routes, use the ROUTER ISIS mode previously
shown.
• Include BGP, directly connected, RIP, or user-congured (static) routes in IS-IS.
ROUTER ISIS mode
redistribute {bgp as-number | connected | rip | static} [level-1 level-1-2 | level-2] [metric
metric-value] [metric-type {external | internal}] [route-map map-name]
Congure the following parameters:
• level-1, level-1-2, or level-2: assign all redistributed routes to a level. The default is level-2.
• metric-value: the range is from 0 to 16777215. The default is 0.
• metric-type: choose either external or internal. The default is internal.
• map-name: enter the name of a congured route map.
• Include specic OSPF routes in IS-IS.ROUTER ISIS mode
redistribute ospf process-id [level-1| level-1-2 | level-2] [metric value] [match external {1
| 2} | match internal] [metric-type {external | internal}] [route-map map-name]
Congure the following parameters:
• process-id: the range is from 1 to 65535.
• level-1, level-1-2, or level-2: assign all redistributed routes to a level. The default is level-2.
• metric value: the range is from 0 to 16777215. The default is 0.
• metric value: the range is from 0 to 16777215. The default is 0.
• match external: the range is 1 or 2.
• match internal
• metric-type: external or internal.
• map-name: name of a congured route map.
To view the IS-IS conguration globally (including both IPv4 and IPv6 settings), use the show running-config isis command in
EXEC Privilege mode. To view the current IPv4 IS-IS conguration, use the show config command in ROUTER ISIS mode. To view the
current IPv6 IS-IS conguration, use the
show config command in ROUTER ISIS-ADDRESS FAMILY IPV6 mode.
412
Intermediate System to Intermediate System
To Next Page
Loading...
