The range of domain IDs is from 1 to 1000.
2 Enter the port-channel number that acts as the interconnect trunk.
VLT DOMAIN CONFIGURATION mode
peer-link port-channel id-number
3 Enter the VLAN ID number of the VLAN where the VLT forwards packets received on the VLTi from an adjacent peer that is down.
VLT DOMAIN CONFIGURATION mode
peer-down-vlan vlan interface number
Conguring Enhanced VLT (Optional)
To congure enhanced VLT (eVLT) between two VLT domains on your network, use the following procedure.
For a sample conguration, refer to eVLT Conguration Example. To set up the VLT domain, use the following commands.
1 Congure the port channel to be used for the VLT interconnect on a VLT switch and enter interface conguration mode.
CONFIGURATION mode
interface port-channel id-number
Enter the same port-channel number congured with the peer-link port-channel command in the Enabling VLT and Creating
a VLT Domain
.
2 Add one or more port interfaces to the port channel.
INTERFACE PORT-CHANNEL mode
channel-member interface
interface: specify one of the following interface types:
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.
3 Enter VLT-domain conguration mode for a specied VLT domain.
CONFIGURATION mode
vlt domain domain-id
The range of domain IDs is from 1 to 1000.
4 Enter the port-channel number that acts as the interconnect trunk.
VLT DOMAIN CONFIGURATION mode
peer-link port-channel id-number
5 Congure the IP address of the management interface on the remote VLT peer to be used as the endpoint of the VLT backup link for
sending out-of-band hello messages.
VLT DOMAIN CONFIGURATION mode
back-up destination ip-address [interval seconds]
You can optionally specify the time interval used to send hello messages. The range is from 1 to 5 seconds.
6 When you create a VLT domain on a switch, Dell Networking OS automatically creates a VLT-system MAC address used for internal
system operations. To explicitly congure the default MAC address for the domain by entering a new MAC address, use the following
command.
VLT DOMAIN CONFIGURATION mode
system-mac mac-address mac-address
Virtual Link Trunking (VLT)
903
To Next Page
Loading...
Need help?
General
