Denso BHT-1505B - Page 219

207
Barode Handy Terminal
Message BHT Response Cause Countermeasure
The BHT displays this error
message and automatically
runs the execution program
from the point of start-up.
Operation was terminated
without turning OFF the
power normally with the
resume function set, and
therefore resume info has
been lost.
If this error occurs
frequently, make a note of
the displayed code and
contact your system
administrator.
After displaying this error
message, the BHT may start
a user program other than
the preset auto-start
execution program or display
the message “No execution
program loaded.”
Your settings made in
System Mode contain an
error.
Contact your system
administrator.
(If th
is error occurs, the
System Mode settings revert
to the factory defaults.)
If this error occurs, the
warning tone beeps five
times.
An error has occurred
during execution of
System Program.
Unload and reload the
battery cartridge, then turn
the BHT on.
If this error occurs
frequently, contact your
system administrator.
The message is continuously
displayed.
An error has occurred
during execution of
System Program. The
application restarts from
the beginning.
If this error occurs
frequently, contact your
system administrator.