Digi Connect IT 16 User Manual

Interfaces Local Area Networks (LANs)
Digi Connect IT® 16/48 User Guide
129
1. Log into the Connect IT 16/48 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create the LAN1 interface:
a. Add the interface:
(config)> add network interface LAN1
(config network interface LAN1)>
b. Configure the LAN1 interface:
i. Enter device ? to view available devices and the proper syntax.
(config network interface LAN1)> device ?
Device: The network device used by this network interface.
Format:
/network/device/eth1
/network/device/eth2
/network/bridge/LAN
/network/bridge/Example_bridge
/network/wireless/ap/digi_ap
/network/wireless/ap/Example_AP
Current value:
(config network interface LAN1)> device
ii. Set the device for the LAN1 interface:
n If you are configuring a Wi-Fi enabled Connect IT 16/48W , set the device to
/network/bridge/Example_bridge.
(config network interface LAN1)> device
/network/bridge/Example_bridge
(config network interface LAN1)>
n If you are configuring a non-Wi-Fi Connect IT 16/48, set the device to
/network/device/eth1 .
(config network interface LAN1)> device /network/device/eth1
(config network interface LAN1)>
c. Configure the firewall zone for the LAN1 interface to internal:
(config network interface LAN1)> zone internal
(config network interface LAN1)>

Digi Connect IT 16 Specifications

General

Brand	Digi
Model	Connect IT 16
Category	Server
Language	English