Digi Connect IT 16 - Page 240

Virtual Private Networks (VPN) IPsec
Digi Connect IT® 16/48 User Guide
240
b. Click to expand ID.
i. Select the ID type:
n Auto: The ID will be automatically determined from the value of the tunnels
endpoints.
n Raw: Enter an IDand have it passed unmodified to the underlying IPsec stack.
For Raw IDvalue, type the ID that will be passed.
n Any: Any ID will be accepted.
n IPv4: The ID will be interpreted as an IP address and sent as an ID_IPV4_ADDR
IKE identity.
For IPv4 IDvalue, type an IPv4 formatted ID. This can be a fully-qualified
domain name or an IPv4 address.
n IPv6: The ID will be interpreted as an IP address and sent as an ID_IPV6_ADDR
IKE identity.
For IPv6 IDvalue, type an IPv6 formatted ID. This can be a fully-qualified
domain name or an IPv6 address.
n RFC822/Email: The ID will be interpreted as an RFC822 (email address).
For RFC822 ID value, type the IDin internet email address format.
n FQDN: The ID will be interpreted as FQDN (Fully Qualified Domain Name) and
sent as an ID_FQDN IKE identity.
For FQDN ID value, type the IDas an FQDN.
n KeyID: The ID will be interpreted as a Key ID and sent as an ID_KEY_ID IKE
identity.
For KEYIDID value, type the key ID.
19. Click to expand Remote endpoint.
a. For Hostname, select either a hostname or IP address. If your device is not configured to
initiate the IPsec connection (see IKE > Initiate connection), you can also use the
keyword any, which means that the hostname is dynamic or unknown.
b. Click to expand ID.
i. Select the ID type:
n Auto: The ID will be automatically determined from the value of the tunnels
endpoints.
n Raw: Enter an IDand have it passed unmodified to the underlying IPsec stack.
For Raw IDvalue, type the ID that will be passed.
n Any: Any ID will be accepted.
n IPv4: The ID will be interpreted as an IPv4 address and sent as an ID_IPV4_
ADDR IKE identity.
For IPv4 IDvalue, type an IPv4 formatted ID. This can be a fully-qualified
domain name or an IPv4 address.
n IPv6: The ID will be interpreted as an IPv6 address and sent as an ID_IPV6_
ADDR IKE identity.
For IPv6 IDvalue, type an IPv6 formatted ID. This can be a fully-qualified
domain name or an IPv6 address.