Digi Connect IT 16 User Manual

Services Location information
Digi Connect IT® 16/48 User Guide
389
b. Set the radius of the circle:
(config service location geofence test_geofence)> radius radius
(config service location geofence test_geofence)>
where radius is an integer followed by m or km, for example, 100m or 1km.
n If boundary is set to polygonal:
a. Set the coordinates of one vertex of the polygon. A vertex is the point at which two
sides of a polygon meet.
i. Add a vertex:
(config service location geofence test_geofence)> add
coordinates end
(config service location geofence test_geofence coordinates
0)>
ii. Set the latitude and longitude of the vertex:
(config service location geofence test_geofence coordinates
0)> latitude int
(config service location geofence test_geofence coordinates
0)> longitude int
(config service location geofence test_geofence coordinates
0)>
where int is:
l For latitude, any integer between -90 and 90, with up to six decimal
places.
l For longitude, any integer between -180 and 180, with up to six decimal
places.
iii. Configure additional vortices:
(config service location geofence test_geofence coordinates
0)> ..
(config service location geofence test_geofence coordinates)>
add end
(config service location geofence test_geofence coordinates
1)> latitude int
(config service location geofence test_geofence coordinates
1)> longitude int
(config service location geofence test_geofence coordinates
1)>
where int is:
l For latitude, any integer between -90 and 90, with up to six decimal
places.
l For longitude, any integer between -180 and 180, with up to six decimal
places.
Repeat for each vortex of the polygon.

Digi Connect IT 16 Specifications

General

Brand	Digi
Model	Connect IT 16
Category	Server
Language	English