Digi Connect IT 16 User Manual

Interfaces Wide Area Networks (WANs)
Digi Connect IT® 16/48 User Guide
76
4. For Match modem by, select the matching criteria used to determine if this modem
configuration applies to the currently attached modem:
n Any modem: Applies this configuration to any modem that is attached.
n IMEI: Applies this configuration only to a modem that matches the identified IMEI.
l If IMEI is selected, for Match IMEI, type the IMEI of the modem that this
configuration should be applied to.
n Port: Applies this configuration to a modem attached to the identified physical port.
l If Port is selected, for Match Port, select the modem's port.
The default is Any modem.
5. For Active SIMslot, select the SIMslot that should be used by the modem, or select Any to
use any SIMslot. The default is Any.
6. If Active SIMslot is set to Any, for Preferred SIMslot, select the SIMslot that should be
considered the preferred slot for this modem, or select None. In the event of a failover to a
non-preferred SIM, or if manual SIM switching is used to switch to a non-preferred SIM, the
modem will attempt to reconnect to the SIM in the preferred SIMslot. None is the default.
7. For Maximum number of interfaces, type the number of interfaces that can be configured to
use this modem. This is used when using dual-APN SIMs. The default is 1.
8. Enable Carrier switching to allow the modem to automatically match the carrier for the active
SIM. Carrier switching is enabled by default.
9. For Access technology, select the type of cellular technology that this modem should use to
access the cellular network, or select All technologies to configure the modem to use the best
available technology. The default is All technologies.
10. For Antennas, select whether the modem should use the main antenna, the auxiliary antenna,
or both the main and auxiliary antennas.
11. Click Apply to save the configuration and apply the change.
Command line
1. Log into the Connect IT 16/48 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Modem configurations are enabled by default. To disable:
(config)> network modem wwan enable false
(config)>

Digi Connect IT 16 Specifications

General

Brand	Digi
Model	Connect IT 16
Category	Server
Language	English