Digi IX30 User Manual

IX30 User Guide
10
Configure SureLink active recovery for PPP-over-L2TP 457
L2TP with IPsec 465
Show L2TP tunnel status 465
L2TPv3 Ethernet 467
Configure an L2TPv3 tunnel 467
Show L2TPV3 tunnel status 472
NEMO 473
Configure a NEMO tunnel 473
Show NEMO status 479
Services
Allow remote access for web administration and SSH 482
Configure the web administration service 486
Configure SSHaccess 496
Use SSH with key authentication 504
Generating SSH key pairs 504
Configure telnet access 507
Configure DNS 512
Show DNS server 518
WANbonding 519
Simple Network Management Protocol (SNMP) 524
SNMP Security 524
Configure Simple Network Management Protocol (SNMP) 524
Download MIBs 529
Location information 531
Configure the location service 532
Configure the device to use a user-defined static location 534
Configure the device to accept location messages from external sources 536
Forward location information to a remote host 541
Configure geofencing 547
Show location information 560
Modbus gateway 561
Configure the Modbus gateway 562
Show Modbus gateway status and statistics 575
System time 579
Configure the system time 579
Manually set the system date and time 583
Network Time Protocol 583
Configure the device as an NTP server 584
Show status and statistics of the NTP server 589
Configure a multicast route 590
Ethernet network bonding 593
Enable service discovery (mDNS) 598
Use the MQTTbroker service 602
Show MQTTbroker information 612
Use the iPerf service 613
Example performance test using iPerf3 618
Configure the ping responder service 618
Example performance test using iPerf3 622
Applications
Develop Python applications 625

Digi IX30 Specifications

General

Category	Network Router
Model	IX30
Serial Ports	1 x RS-232
Operating Temperature	-40° C to 70° C
Connectivity	Ethernet
USB Ports	1 x USB 2.0
Cellular Interface	4G LTE Cat 4
Wi-Fi	802.11 a/b/g/n/ac
SIM Slots	1
Processor	ARM Cortex-A9
Memory	1 GB RAM