Interfaces Wide Area Networks (WANs)
IX30 User Guide
122
4. (Optional) Change the Timeout for the carrier scan. The default is 300 seconds.
5. When the Carrier Scan window opens, the results of the most recent previous scan are
displayed. If there is no previous scan available, or to refresh the list, click SCAN.
6. The current carrier is highlighted in green. To switch to a different carrier:
a. Highlight the appropriate carrier and click SELECT.
The Carrier selection dialog opens.
b. For Carrier selection mode, select one of the following:
n
Manual/Automatic: The device will use automatic carrier selection if this carrier is
not available.
n
Manual: Does not allow the device to use automatic carrier selection if this carrier
is not available.
Note If Manual is selected, your modem must support the Network technology or
the modem will lose cellular connectivity. If you are using a cellular connection to
perform this procedure, you may lose your connection and the device will no longer
be accessible.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX30
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the Admin CLI prompt, type:
> modem scan
Issuing network scan, this may take some time...
Status Carrier PLMN ID Technology
--------- -------- ------- ----------
Available T-Mobile 310260 4G
Available T-Mobile 310260 3G
Available AT&T 310410 4G
Available Verizon 311480 4G
Available 311 490 311490 4G
Available 313 100 313100 4G
>
To Next Page
Loading...
Need help?
General
