Interfaces Wide Area Networks (WANs)
IX30 User Guide
121
n
manual_automatic—The device will attempt to connect to the carrier identified in the
Network PLMN ID. If the carrier is not available, the device will fall back to using
automatic carrier selection.
4. If carrier section mode is set to manual or manual_automatic, set the network PLMN ID:
(config)> network interface modem modem operator plmn_ID
(config)>
Note You can use the modem scan command at the Admin CLI to scan for available carriers
and determine their PLMN ID. See Scan for available cellular carriers for details.
5. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Scan for available cellular carriers
You can scan for available carriers and determine their network PLMN ID by using the modem scan
command at the Admin CLI.
Web
1. Log into the IX30 WebUI as a user with Admin access.
2. From the main menu, click Status > Modems.
3. croll to the Connection Status section and click SCAN.
The Carrier Scan window opens.
To Next Page
Loading...
Need help?
General
