Interfaces Wide Area Networks (WANs)
IX30 User Guide
131
12. (Optional) Click to expand MACaddress allowlist.
If allowlist entries are specified, incoming packets will only be accepted from the listed MAC
addresses.
a. Click to expand MACaddress allowlist.
b. For Add MACaddress, click .
c. Type the MAC address.
13. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX30
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new WAN or edit an existing one:
n
To create a new WAN named my_wan:
(config)> add network interface my_wan
(config network interface my_wan)>
n
To edit an existing WAN named my_wan, change to the my_wan node in the
configuration schema:
(config)> network interface my_wan
(config network interface my_wan)>
4. Set the appropriate firewall zone:
(config network interface my_wan)> zone zone
(config network interface my_wan)>
See Firewall configuration for further information.
5. Select an Ethernet device or a bridge. See Bridging for more information about bridging.
a. Enter device ? to view available devices and the proper syntax.
(config network interface my_wan)> device ?
Device: The network device used by this network interface.
Format:
/network/device/eth1
/network/device/eth2
/network/device/loopback
/network/bridge/lan
/network/wireless/ap/digi_ap
To Next Page
Loading...
Need help?
General
