Digi IX30 User Manual

Interfaces Wide Area Networks (WANs)
IX30 User Guide
132
Current value:
(config network interface my_wan)> device
b. Set the device for the LAN:
(config network interface my_wan)> device device
(config network interface my_wan)>
6. Configure IPv4 settings:
n
IPv4 support is enabled by default. To disable:
(config network interface my_wan)> ipv4 enable false
(config network interface my_wan)>
n
Configure the WAN to be a DHCP client:
(config network interface my_wan)> ipv4 type dhcp
(config network interface my_wan)>
a. Optional IPv4 configuration items:
i. Set the IP metric:
(config network interface my_wan)> ipv4 metric num
(config network interface my_wan)>
See Configure WAN/WWAN priority and default route metrics for further information
about metrics.
ii. Set the relative weight for default routes associated with this interface. For multiple
active interfaces with the same metric, the weight is used to load balance traffic to
the interfaces.
(config network interface my_wan)> ipv4 weight num
(config network interface my_wan)>
iii. Set the management priority. This determines which interface will have priority for
central management activity. The interface with the highest number will be used.
(config network interface my_wan)> ipv4 mgmt num
(config network interface my_wan)>
iv. Set the MTU:
(config network interface my_wan)> ipv4 mtu num
(config network interface my_wan)>
v. Configure how to use DNS:
(config network interface my_wan)> ipv4 use_dns value
(config network interface my_wan)>

Digi IX30 Specifications

General

Category	Network Router
Model	IX30
Serial Ports	1 x RS-232
Operating Temperature	-40° C to 70° C
Connectivity	Ethernet
USB Ports	1 x USB 2.0
Cellular Interface	4G LTE Cat 4
Wi-Fi	802.11 a/b/g/n/ac
SIM Slots	1
Processor	ARM Cortex-A9
Memory	1 GB RAM