Digi IX30

Interfaces Wide Area Networks (WANs)
IX30 User Guide
142
n
sim_slot
Set which SIM slot must be in active for this WWAN to be used:
(config network interface my_wwan)> modem sim_slot value
(config network interface my_wwan)>
where value is either 1 or 2.
7. Set the PIN for the SIM. Leave blank if no PIN is required.
(config network interface my_wwan)> modem pin value
(config network interface my_wwan)>
8. Set the phone number for the SIM, for SMS connections:
(config network interface my_wwan)> modem phone num
(config network interface my_wwan)>
Normally, this should be left blank. It is only necessary to complete this field if the SIM does
not have a phone number or if the phone number is incorrect.
9. Roaming is enabled by default. To disable:
(config network interface my_wwan)> modem roaming false
(config network interface my_wwan)>
10. Set the carrier selection mode:
(config network interface my_wwan)> modem operator_mode value
(config network interface my_wwan)>
where value is one of:
n
automatic: The cellular carrier is selected automatically by the device.
n
manual: The cellular carrier must be manually configured. If the configured network is
not available, no cellular connection will be established.
n
manual_automatic: The carrier is manually configured. If the configured network is not
available, automatic carrier selection is used.
If manual or manual_automatic is set:
a. Set the Network PLMN ID:
(config network interface my_wwan)> modem operator PLMN_ID
(config network interface my_wwan)>
b. Set the cellular network technology:
(config network interface my_wwan)> modem operator_technology value
(config network interface my_wwan)>
where value is one of:
n
all: The best available technology will be used.
n
2G: Only 2G technology will be used.
n
3G: Only 3G technology will be used.