Interfaces Local Area Networks (LANs)
IX30 User Guide
156
(config network interface my_lan)> ipv4 type dhcp
(config network interface my_lan)>
These instructions assume that the LAN will use a static IP address for its IPv4
configuration.
a. Set the IPv4 address and subnet of the LAN interface. Use the format IPv4_
address/netmask, for example, 192.168.2.1/24.
(config network interface my_lan)> ipv4 address ip_address/netmask
(config network interface my_lan)>
b. Optional IPv4 configuration items:
i. Set the IP metric:
(config network interface my_lan)> ipv4 metric num
(config network interface my_lan)>
ii. Set the relative weight for default routes associated with this interface. For multiple
active interfaces with the same metric, the weight is used to load balance traffic to
the interfaces.
(config network interface my_lan)> ipv4 weight num
(config network interface my_lan)>
iii. Set the management priority. This determines which interface will have priority for
central management activity. The interface with the highest number will be used.
(config network interface my_lan)> ipv4 mgmt num
(config network interface my_lan)>
iv. Set the MTU:
(config network interface my_lan)> ipv4 mtu num
(config network interface my_lan)>
c. Enable the DHCP server:
(config network interface my_lan)> ipv4 dhcp_server enable true
See DHCP servers for information about configuring the DHCP server.
7. (Optional) Configure IPv6 settings:
a. Enable IPv6 support:
(config network interface my_lan)> ipv6 enable true
(config network interface my_lan)>
b. Set the IPv6 type to DHCP:
(config network interface my_lan)> ipv6 type dhcpv6
(config network interface my_lan)>
c. Generally, the default settings for IPv6 support are sufficient. You can view the default IPv6
settings by using the question mark (?):
To Next Page
Loading...
Need help?
General
