Digi IX30 User Manual

Interfaces Local Area Networks (LANs)
IX30 User Guide
157
(config network interface my_lan)> ipv6 ?
IPv6
Parameters Current Value
---------------------------------------------------------------------
----------
enable true Enable
metric 0 Metric
mgmt 0 Management priority
mtu 1500 MTU
prefix_id 1 Prefix ID
prefix_length 48 Prefix length
type prefix_delegation Type
weight 10 Weight
Additional Configuration
---------------------------------------------------------------------
----------
connection_monitor Active recovery
dhcpv6_server DHCPv6 server
(config network interface my_lan)>
View default settings for the IPv6 DHCP server:
(config network interface my_lan)> ipv6 dhcpv6_server ?
DHCPv6 server: The DHCPv6 server settings for this network interface.
Parameters Current Value
---------------------------------------------------------------------
----------
enable true Enable
(config network interface my_lan)>
d. Modify any of the remaining default settings as appropriate. For example, to change the
minimum length of the prefix:
(config network interface my_lan)> ipv6 prefix_length 60
(config network interface my_lan)>
If the minimum length is not available, then a longer prefix will be used.
See Configure WAN/WWAN priority and default route metrics for further information about
metrics.
8. (Optional) To configure 802.1x port based network access control:

Digi IX30 Specifications

General

Category	Network Router
Model	IX30
Serial Ports	1 x RS-232
Operating Temperature	-40° C to 70° C
Connectivity	Ethernet
USB Ports	1 x USB 2.0
Cellular Interface	4G LTE Cat 4
Wi-Fi	802.11 a/b/g/n/ac
SIM Slots	1
Processor	ARM Cortex-A9
Memory	1 GB RAM