Digi IX30 User Manual

Virtual Private Networks (VPN) IPsec
IX30 User Guide
362
(config)> add vpn ipsec tunnel ipsec_example policy end
(config vpn ipsec tunnel ipsec_example policy 0)>
c. Set the type of local traffic selector:
(config vpn ipsec tunnel ipsec_example policy 0)> local type value
(config vpn ipsec tunnel ipsec_example policy 0)>
where value is one of:
n
address: The address of a local network interface.
Set the address:
i. Use the ? to determine available interfaces:
(config vpn ipsec tunnel ipsec_example policy 0)> local
address ?
Address: The local network interface to use the address of.
This field must be set when 'Type' is set to 'Address'.
Format:
defaultip
defaultlinklocal
eth1
eth2
loopback
Current value:
(config vpn ipsec tunnel ipsec_example policy 0)> local
address
ii. Set the interface. For example:
(config vpn ipsec tunnel ipsec_example policy 0)> local
address eth1
(config vpn ipsec tunnel ipsec_example policy 0)>
n
network: The subnet of a local network interface.
Set the network:
i. Use the ? to determine available interfaces:
(config vpn ipsec tunnel ipsec_example policy 0)> local
network ?
Interface: The network interface.
Format:
defaultip
defaultlinklocal
eth1
eth2
loopback
Current value:

Digi IX30 Specifications

General

Category	Network Router
Model	IX30
Serial Ports	1 x RS-232
Operating Temperature	-40° C to 70° C
Connectivity	Ethernet
USB Ports	1 x USB 2.0
Cellular Interface	4G LTE Cat 4
Wi-Fi	802.11 a/b/g/n/ac
SIM Slots	1
Processor	ARM Cortex-A9
Memory	1 GB RAM