Digi IX30 User Manual

Services WANbonding
IX30 User Guide
523
For example:
(config)> add network sdwan wan_bonding interfaces end
/network/interface/wan1
(config)>
b. Repeat for each additional interface.
9. Set the password for authentication to the WAN bonding web interface.
The WAN bonding web interface can be used to view detailed WAN bonding statistics and to
fine-tune the WAN bonding process, and is accessed via a web browser at http://ip-
address:8088, where ip-address is the IP address of the local IX30 device.
(config)> network sdwan wan_bonding web_interface password password
(config)>
10. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
11. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Digi IX30 Specifications

General

Category	Network Router
Model	IX30
Serial Ports	1 x RS-232
Operating Temperature	-40° C to 70° C
Connectivity	Ethernet
USB Ports	1 x USB 2.0
Cellular Interface	4G LTE Cat 4
Wi-Fi	802.11 a/b/g/n/ac
SIM Slots	1
Processor	ARM Cortex-A9
Memory	1 GB RAM