Services Ethernet network bonding
IX30 User Guide
594
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Ethernet bonding.
4. For Add Bond device, click
The bond device is enabled by default. To disable, toggle off Enable.
5. For Mode, selected either:
n
Active-backup: Transmits data on only one of the bonded devices at a time. When the
active device fails, the next available device in the list is chosen. This mode provides for
fault tolerance.
n
Round-robin: Alternates between bonded devices to provide load balancing as well as
fault tolerance.
6. Click to expand Devices.
To Next Page
Loading...
Need help?
General
