Digi IX30 User Manual

Services Ethernet network bonding
IX30 User Guide
597
n
round-robin: Alternates between bonded devices to provide load balancing as well as
fault tolerance.
6. Add Ethernet devices:
a. Use the ? to determine available devices:
(config network bond eth_bond)> ... network device ?
Additional Configuration
---------------------------------------------------------------------
-------
loopback
(config network bond eth_bond)>
b. Add a device:
(config network bond eth_bond)> add device /network/device/
(config network bond eth_bond)>
c. Repeat to add additional devices.
7. Create a new network interface that is linked to the Ethernet bond:
a. Type ... to return to the root of the configuration:
(config network bond eth_bond)> ...
(config)>
b. Create a new interface, for example:
(config)> add network interface eth_bond_interface
(config network interface eth_bond_interface)>
c. For device, select the Ethernet bond created above:
(config network interface eth_bonding_interface)> device
/network/bond/eth_bond
(config network interface eth_bonding_interface)>
d. Complete the rest of the interface configuration. See Configure a Wide Area Network (WAN)
or Configure a Local Area Network (LAN) for further information.
8. Disable any other interfaces associated with the devices that were added to the Ethernet bond.
For example, if ETH1 and ETH2 were added to the Ethernet bond, and they are included with
the ETH1 and ETH2 interfaces:
a. Type ... to return to the root of the configuration:
(config network interface eth_bonding_interface)> ...
(config)>

Digi IX30 Specifications

General

Category	Network Router
Model	IX30
Serial Ports	1 x RS-232
Operating Temperature	-40° C to 70° C
Connectivity	Ethernet
USB Ports	1 x USB 2.0
Cellular Interface	4G LTE Cat 4
Wi-Fi	802.11 a/b/g/n/ac
SIM Slots	1
Processor	ARM Cortex-A9
Memory	1 GB RAM