User authentication Authentication groups
IX30 User Guide
706
a. Enable captive portal access rights for users of this group by checking the box next to
Captive portal access.
b. Click Captive portals to expand the Captive portal node.
c. For Add Captive portal, click .
d. In the Captive portal dropdown, select a captive portal to which users of this group will
have access.
e. Click again to add additional captive portals.
9. Interactive shell access
Shell access is not available if the Allow shell parameter has been disabled. See Disable shell
access for more information about the Allow shell parameter.
10. (Optional) Enable users that belong to this group to query the device for Nagios monitoring by
checking the box next to Nagios access.
11. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX30
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Use the add auth group command to add a new authentication. For example, to add a group
named test:
(config)> add auth group test
(config auth group test)>
4. Enable access rights for the group:
n
Admin access:
(config auth group test)> acl admin enable true
(config)>
n
Set the access level for Admin access:
(config)> auth group admin acl admin level value
(config)>
where value is either:
l
full: provides users of this group with the ability to manage the IX30 device by using
the WebUI or the Admin CLI.
l
read-only: provides users of this group with read-only access to the WebUI and
Admin CLI.
The default is full.
To Next Page
Loading...
Need help?
General
